Pianos consistently make movers annual list of products that are most frequently damaged. Grand pianos are especially bothersome. Practicing the following procedures for taking apart, cushioning and filling grand pianos will prevent damage, lower claims expense, and enhance consumer satisfaction.
1) At least three people are required to deal with an infant grand piano. If the infant grand piano requires to increase or down stairs or if a complete or show grand piano needs to be carried, a minimum of 4 individuals are required.
2) Constantly complete a precise and comprehensive stock. It may be more effective or essential to utilize a visual stock to sufficiently describe and show pre-existing damage.
3) As different parts are taken apart, please place all hardware in a correctly labeled parts bag and after that position the parts bag in a "Components Box".
4) Eliminate the music rack (lyre) from its track by pulling it toward the keyboard. Wrap it in a clean furnishings pad.
5) Disconnect the cover by getting rid of the hinge pins. Have a single person wiggle the cover, holding it opposite the hinge, while a second individual works the pin loose. Please be cautious not to harm the wood with the pliers or with the pin itself. If needed, cover the jaws of the pliers with a small fabric to help avoid damage to the wood. Wrap the cover in a clean furnishings pad.
6) Get rid of the prop that holds the lid open and cover it in a tidy furniture pad. The prop has a hinge pin and remains in two pieces.
7) Eliminate the pedal assembly and cover it in a clean furnishings pad. The braces at the back of the assembly rest in slots at each end. When getting rid of the screws, please be cautious not to drop the braces. In addition, please be specifically careful with the push-rods so that they will not get bent. As you face the piano, number the push-rods from left to right as "1", "2", and "3", by positioning a piece of masking tape with the proper number on each rod. Keep in have a peek here mind: If masking tape is not available, please use correctly labeled parts bags for this purpose. When reassembling at destination, please make sure to put the rods in the right order so that the pedals will work properly.
8) Pad the piano by putting a clean rolled furniture pad (stretch-wrap the pad to avoid it from unrolling) on the cover of the keyboard to avoid it from flopping open while you handle the piano. Keep in mind: Please guarantee that the surface area of the piano is dust-free before padding it.
9) Position a piano board and connect the straps so that it is all set to receive the piano. The raised brace on the piano board should be at the keyboard end of the piano.
10) Get rid of the left front leg by positioning one person underneath the piano at the left end of the keyboard. Be sure to have two people lifting the corner of the piano while the 3rd individual gets rid of the leg. Keep in mind: Please be sure to keep in mind which legs were removed from which positions since some pianos have legs that are not interchangeable.
11) Location the piano on the browse this site piano board by decreasing the "leg-less" end onto the board. Please be sure to lift the entire piano a little while completing this maneuver to avoid unnecessary pressure on the remaining, connected legs as the piano suggestions. Be sure that the piano is centered comfortably against the brace at the end of the piano board.
12) Get rid of the two staying legs and wrap them in tidy furniture pads. These legs are kept in place by a "crucial and slot" arrangement. To get rid of the leg, slide it inward toward the center of the piano till it comes out of the slot.
13) Protect the piano to the piano board by bringing the ends of the straps together and securing them. Place folded burlap pads over the furnishings pads however under the straps to provide extra protection to the edges of the piano. To prevent the strap near the narrow end of the piano from slipping off, connect the loose ends of the 2 straps together.
14) To move the piano over a flat, level surface, tilt the piano and piano board and place a four-wheel dolly under the center of the piano board.
15) To move the piano up or down stairs, utilize the piano board as a skid. After sufficiently padding the stairs for security versus house damage, place the keyboard end of the piano toward the bottom of the stairs. Attach a hump strap to the leading end of the piano board to avoid the piano from slipping.
16) To load the piano, leave it on the piano board and place it in a tier as the first base item with the keyboard facing the wall of the preceding tier. The very best location to fill the padded lid is between the piano and the preceding tier or between the wall and the piano.
Grand pianos represent a considerable difficulty, they can be moved without damage by utilizing common sense and practicing the procedures noted above.